Assembly and shaping of the handles are works that I tend to procrastinate the most. Probably because at this stage there is a lot of effort sunk into the project already but it is still possible to do an irreparable screw-up that would toss all that work out of the window.
With the project being more than half-finished, metalworking shifts to woodworking – making the blocks and handles. And this started by squaring off the wood on the table saw.
As far as design goes, I like simple looks, even though that does not always mean simple construction. Designs where nothing is visible but the wood of the handle and the steel of the blade do have a certain "something", in my opinion. However, these knives do require bolsters between the blade and the handle.
After the blades are taken out of the tumbler it is finally possible to finish them, ie to grind out the final outline and etch logos and numbers.
While the blades were merrily rumbling in the tumbler I have done other things, although I did not stop working on these knives completely – I took some time to choose pieces of wood for the handles and the stands. To pick eight proper pieces was not so easy. Not that I do not have enough material to choose from...
Polishing is a knife-maker's bane.
After the basic grind comes the most critical step in the manufacture – steel heat treatment.
Primary bevel grind is one of the key steps in manufacture and its result is finally something that actually looks like a knife blade.
Having templates allows me to start the actual work, so let's go.
I am working on a small commission and decided it won't go amiss to document the process.
